Adstud must be applied evenly on the tile covering with a hard rubber trowel. Grout material has to be completely filled between entire joint areas, the application has to be done diagonally with respect to the joints. Remove most of the excess grout immediately  using the trowel, leaving only a thin film on the tile.

Cleaning Preparation

1. First cleaning with rubber trowel: once the joints have been filled, remove any excess grout that is left on the tiles immediately with the rubber trowel (working diagonally).
2. Cleaning: prepare the tray with clean water. Change the washing water frequently so that it is always clean. Replace the sponge or felt if impregnated with the product.
   First pass
3. Cleaning with cellulose sponge: clean when the grout is still fresh, using a cellulose sponge dampened with the water from tray. Use circular movements to soften the film of grout on the tiles and finish the joints. Collect up the emulsion formed on the tiles using the sponge.
4. Cleaning with rough scrubbing pad for rough surfaces: for more rough surfaces, clean when the grout is still fresh, using a felt pad dampened with the water from tray. Use circular movements to soften the film of grout on the tiles and finish the joints. Collect up the emulsion formed on the tiles using the sponge.
   Second pass
5. Finishing with a cellulose sponge: finish cleaning with a cellulose sponge dampened with water from tray. Cleaning action has to be always diagonally to the tile joints, to avoid any material been removed from the joints itself. Do not walk on the damp floors for at least 12 – 24 hours, to  avoid leaving dirt.
6. Finishing with foam rubber sponge for a smoother joint: for a smooth finish, complete cleaning with a foam rubber sponge dampened with water from tray, working diagonally to the tiles so as not to dig into the joints.

Appearance	part A coloured paste/part B neutral paste.
Specific weight	Part A ≈ 4.5gm. + Part B ~ 500gm.
Viscosity	≈120000 mPa-s, rotor 93 RPM 10 Brookfield metho
Mineralogical nature of inert material	silicate-crystalline
Chemical nature	epoxy resin (part A)/Hardner (part B)
Grading	≈0-250µ
Shelf life	≈ 18month in the original packaging
Warning	Protect from, frost, avoid direct exposure to sunlight and sources of heat
Pack	5Kg Buckt, 3Kg Bucket
Mixing ratio	Part A : Part B= 900gm:100gm.
Pot life at +23C	≥ 45min
Teamerature range for application	from +5 °C to +30 °C
Width of Joints	from 0to5mm
Foot traffic	≈24hrs.
Interval before normal use	≈ 3 days (mechanical resistance)/~7days (chemical resist.)
Coverage
-as an adhesive	≈2-4kg/m²
-as a grout	see Coverage table